eCFR.io
Daily eCFR

Table 2 to Subpart XXXXXX of Part 63—Applicability of General Provisions to Metal Fabrication or Finishing Area Sources

Applicability of General Provisions to Metal Fabrication or Finishing Area Sources

  1. CFR
  2. ›
  3. Title 40
  4. ›
  5. Chapter I
  6. ›
  7. Part 63
  8. ›
  9. Subpart XXXXXX
  10. ›
  11. Subject Group Other Requirements and Information
  12. ›
  13. Appendix Table 2 to Subpart XXXXXX of Part 63
CorpusDaily eCFR
Displayed edition2026-04-27
Last updated2026-04-27

Table 2 to Subpart XXXXXX of Part 63—Applicability of General Provisions to Metal Fabrication or Finishing Area Sources

Instructions for Table 2—As required in § 63.11523, “General Provisions Requirements,” you must meet each requirement in the following table that applies to you.

CitationSubject
63.11Applicability.
63.2Definitions.
63.3Units and abbreviations.
63.4Prohibited activities.
63.5Construction/reconstruction.
63.6(a), (b)(1)-(b)(5), (c)(1), (c)(2), (c)(5), (g), (i), (j)Compliance with standards and maintenance requirements.
63.9(a)-(d)Notification requirements.
63.10(a), (b) except for (b)(2), (d)(1), (d)(4)Recordkeeping and reporting.
63.12State authority and delegations.
63.13Addresses of State air pollution control agencies and EPA regional offices.
63.14Incorporation by reference.
63.15Availability of information and confidentiality.
63.16Performance track provisions.
1 § 63.11514(g), “Am I subject to this subpart?” exempts affected sources from the obligation to obtain title V operating permits.