Table 8 to Subpart XXXX of Part 63—Initial Compliance With the Emission Limits for Puncture Sealant Application Affected Sources
As stated in § 63.6002, you must show initial compliance with the emission limits for puncture sealant application affected sources according to the following table:
| For . . . | For the following emission limit . . . | You have demonstrated initial compliance if . . . |
|---|---|---|
| 1. Sources complying with the overall control efficiency alternative in § 63.5989(a) | The percent reduction option in Table 3 to this subpart, option 1 | You demonstrate that you conducted the performance tests, determined the overall efficiency of your control system, demonstrated that the applicable limits in Table 3 to this subpart, option 1, have been achieved, and established the operating limits in Table 4 of this subpart for your equipment according to the applicable procedures in § 63.6000(b). |
| 2. Sources complying with the permanent total enclosure and control device efficiency alternative in § 63.5989(b) | The percent reduction option in Table 3 to this subpart, option 1 | You demonstrate that you conducted the performance tests, determined the individual efficiencies of your capture and control systems, demonstrated that the applicable limits in Table 3 to this subpart, option 1, have been achieved, and established the operating limits in Table 4 of this subpart for your equipment according to the applicable procedures in § 63.6000(b). |
| 3. Sources complying with the monthly average alternative in § 63.5989(c) without using an add-on control device | The HAP constituent option in Table 3 to this subpart, option 2 | You demonstrate that the monthly average HAP emissions for each monthly operating period do not exceed the HAP constituent emission limits in Table 3 to this subpart, option 2, determined according to the applicable procedures in § 63.6000(c) and (d)(1). |
| 4. Sources complying with the HAP constituent alternative in § 63.5989(d) by using an add-on control device | The HAP constituent option in Table 3 to this subpart, option 2 | You demonstrate that the monthly average HAP emissions for each monthly operating period do not exceed the HAP constituent emission limits in Table 3 to this subpart, option 2, determined according to the applicable procedures in § 63.6000(c), (d)(2) and (3), and (e) through (f). |