Table 3 to Subpart NNNa of Part 60, Title 40 | Table 3 to Subpart NNN<span class="standard">a</span> of Part 60—Operating Parameters, Operating Parameter Limits and Data Monitoring, Recordkeeping and Compliance Frequencies

Table 3 to Subpart NNNa of Part 60—Operating Parameters, Operating Parameter Limits and Data Monitoring, Recordkeeping and Compliance Frequencies

For the operating parameter applicable to you, as specified in table 2	You must establish the following operating parameter limit . . .	And you must monitor, record, and demonstrate continuous compliance using these minimum frequencies . . .
Data measurement	Data recording	Data averaging period for compliance
Absorbers
1. Exit temperature of the absorbing liquid	Maximum temperature	Continuous	Every 15 minutes	3-hour block average.
2. Exit specific gravity	Exit specific gravity range	Continuous	Every 15 minutes	3-hour block average.
Boilers or process heaters
(with a design heat input capacity <44MW and vent stream is not introduced with or as the primary fuel)
3. Firebox temperature	Minimum firebox temperature	Continuous	Every 15 minutes	3-hour block average.
Catalytic incinerators
4. Temperature in gas stream immediately before the catalyst bed	Minimum temperature	Continuous	Every 15 minutes	3-hour block average.
5. Temperature difference between the catalyst bed inlet and the catalyst bed outlet	Minimum temperature difference	Continuous	Every 15 minutes	3-hour block average.
Carbon adsorbers
6. Total regeneration stream mass flow during carbon bed regeneration cycle(s)	Minimum mass flow during carbon bed regeneration cycle(s)	Continuously during regeneration	Every 15 minutes during regeneration cycle	Total flow for each regeneration cycle.
7. Total regeneration stream volumetric flow during carbon bed regeneration cycle(s)	Minimum volumetric flow during carbon bed regeneration cycle(s)	Continuously during regeneration	Every 15 minutes during regeneration cycle	Total flow for each regeneration cycle.
8. Temperature of the carbon bed after regeneration [and within 15 minutes of completing any cooling cycle(s)]	Maximum temperature of the carbon bed after regeneration	Continuously during regeneration and for 15 minutes after completing any cooling cycle(s)	Every 15 minutes during regeneration cycle (including any cooling cycle)	Average of regeneration cycle.
9. Breakthrough	As defined in § 60.661a	As required by § 60.663a(a)(6)(iii)(B)	Each monitoring event	N/A.
Condensers
10. Exit (product side) temperature	Maximum temperature	Continuous	Every 15 minutes	3-hour block average.
Scrubbers for halogenated vent streams
11. pH of scrubber effluent	Minimum pH	Continuous	Every 15 minutes	3-hour block average.
12. Influent liquid flow	Minimum inlet liquid flow	Continuous	Every 15 minutes	3-hour block average.
13. Influent liquid flow rate and gas stream flow rate	Minimum influent liquid-to-gas ratio	Continuous	Every 15 minutes	3-hour block average.
Thermal incinerators
14. Firebox temperature	Minimum firebox temperature	Continuous	Every 15 minutes	3-hour block average.
Control devices other than an incinerator, boiler, process heater, or flare; or recovery devices other than an absorber, condenser, or carbon adsorber
15. As specified by the Administrator	15. As specified by the Administrator	15. As specified by the Administrator	15. As specified by the Administrator	15. As specified by the Administrator.