Title 14
SECTION 25.103
25.103 Stall speed.
§ 25.103 Stall speed.(a) The reference stall speed, VSR, is a calibrated airspeed defined by the applicant. VSR may not be less than a 1-g stall speed. VSR is expressed as:
where: VCLMAX = Calibrated airspeed obtained when the load factor-corrected lift coefficientis first a maximum during the maneuver prescribed in paragraph (c) of this section. In addition, when the maneuver is limited by a device that abruptly pushes the nose down at a selected angle of attack (e.g., a stick pusher), VCLMAX may not be less than the speed existing at the instant the device operates;
nZW = Load factor normal to the flight path at VCLMAX W = Airplane gross weight; S = Aerodynamic reference wing area; and q = Dynamic pressure.(b) VCLMAX is determined with:
(1) Engines idling, or, if that resultant thrust causes an appreciable decrease in stall speed, not more than zero thrust at the stall speed;
(2) Propeller pitch controls (if applicable) in the takeoff position;
(3) The airplane in other respects (such as flaps, landing gear, and ice accretions) in the condition existing in the test or performance standard in which VSR is being used;
(4) The weight used when VSR is being used as a factor to determine compliance with a required performance standard;
(5) The center of gravity position that results in the highest value of reference stall speed; and
(6) The airplane trimmed for straight flight at a speed selected by the applicant, but not less than 1.13VSR and not greater than 1.3VSR.
(c) Starting from the stabilized trim condition, apply the longitudinal control to decelerate the airplane so that the speed reduction does not exceed one knot per second.
(d) In addition to the requirements of paragraph (a) of this section, when a device that abruptly pushes the nose down at a selected angle of attack (e.g., a stick pusher) is installed, the reference stall speed, VSR, may not be less than 2 knots or 2 percent, whichever is greater, above the speed at which the device operates.
[Doc. No. 28404, 67 FR 70825, Nov. 26, 2002, as amended by Amdt. 25-121, 72 FR 44665, Aug. 8, 2007]