';


Title 16 Part 1512 → Subpart A → §1512.10

Title 16 → Chapter II → Subchapter C → Part 1512 → Subpart A → §1512.10

Electronic Code of Federal Regulations e-CFR

Title 16 Part 1512 → Subpart A → §1512.10

e-CFR data is current as of September 19, 2019

Title 16Chapter IISubchapter CPart 1512Subpart A → §1512.10


Title 16: Commercial Practices
PART 1512—REQUIREMENTS FOR BICYCLES
Subpart A—Regulations


§1512.10   Requirements for tires.

The manufacturer's recommended inflation pressure shall be molded into or onto the sidewall of the tire in lettering no less than 3.2 mm ( 18 in.) in height. The statement of recommended inflation pressure shall be in the English language utilizing Arabic numerals. (The following language is suggested to indicate recommended inflation pressure: “Inflate to __ PSI.”) After inflation to 110 percent of the recommended inflation pressure, the tire shall remain intact on the rim, including while being tested under a load of 2,000 N (450 lbf) in accordance with the rim test, §1512.18(j). Tubular sew-up tires, nonpneumatic tires, and nonmolded wired-on tires are exempt from this section.