';


Title 16 Part 1512 → Subpart A → §1512.15

Title 16 → Chapter II → Subchapter C → Part 1512 → Subpart A → §1512.15

Electronic Code of Federal Regulations e-CFR

Title 16 Part 1512 → Subpart A → §1512.15

e-CFR data is current as of September 16, 2019

Title 16Chapter IISubchapter CPart 1512Subpart A → §1512.15


Title 16: Commercial Practices
PART 1512—REQUIREMENTS FOR BICYCLES
Subpart A—Regulations


§1512.15   Requirements for seat.

(a) Seat limitations. No part of the seat, seat supports, or accessories attached to the seat shall be more than 125 mm (5.0 in) above the top of the seat surface at the point where the seat surface is intersected by the seat post axis. This requirement does not apply to recumbent bicycles.

(b) Seat post. The seat post shall contain a permanent mark or ring that clearly indicates the minimum insertion depth (maximum seat-height adjustment); the mark shall not affect the structural integrity of the seat post. This mark shall be located no less than two seat-post diameters from the lowest point on the post shaft, and the post strength shall be maintained for at least a length of one shaft diameter below the mark. This requirement does not apply to bicycles with integrated seat masts, however, a permanent mark or other means to clearly indicate that the seat or seat posts is safely installed shall be provided.

(c) Adjustment clamps. The seat adjustment clamps shall be capable of securing the seat in any position to which it can be adjusted and preventing movement of the seat in any direction under normal conditions of use. Following the road test, §1512.18(p) (or the sidewalk bicycle proof test, §1512.18(q), as applicable), the seat clamps shall be tested in accordance with the seat adjustment clamps and load test, §1512.18(l).

[43 FR 60034, Dec. 22, 1978, as amended at 76 FR 27888, May 13, 2011]