';


Title 16 Part 1250

Title 16 → Chapter II → Subchapter B → Part 1250

Electronic Code of Federal Regulations e-CFR

Title 16 Part 1250

e-CFR data is current as of November 13, 2019

Title 16Chapter IISubchapter B → Part 1250


Title 16: Commercial Practices


PART 1250—SAFETY STANDARD MANDATING ASTM F963 FOR TOYS


Contents
§1250.1   Scope.
§1250.2   Requirements for toy safety.

Authority: Pub. L. 110-314, sec. 106, 122 Stat. 3016 (August 14, 2008); Pub. L. 112-28, 125 Stat. 273 (August 12, 2011).

Source: 82 FR 8993, Feb. 2, 2017, unless otherwise noted.

return arrow Back to Top

§1250.1   Scope.

This part establishes a consumer product safety standard for toys that mandates provisions of ASTM F963.

return arrow Back to Top

§1250.2   Requirements for toy safety.

(a) Except as provided for in paragraphs (b) and (c) of this section, toys must comply with the provisions of ASTM F963-17, Standard Consumer Safety Specification for Toy Safety, approved May 1, 2017. The Director of the Federal Register approves the incorporation by reference listed in this section in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. You may obtain a copy of this ASTM standard from ASTM International, 100 Barr Harbor Drive, P.O. Box C700, West Conshohocken, PA 19428-2959 USA; phone: 610-832-9585; http://www.astm.org/. You may inspect a copy at the Office of the Secretary, U.S. Consumer Product Safety Commission, Room 820, 4330 East West Highway, Bethesda, MD 20814, telephone 301-504-7923, or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http://www.archives.gov/federal__register/code__of__federal__regulations/ibr__locations.html.

(b) Pursuant to section 106(a) of the Consumer Product Safety Improvement Act of 2008 section 4.2 and Annex 5 or any provision of ASTM F963 that restates or incorporates an existing mandatory standard or ban promulgated by the Commission or by statute or any provision that restates or incorporates a regulation promulgated by the Food and Drug Administration or any statute administered by the Food and Drug Administration are not part of the mandatory standard incorporated in paragraph (a) of this section.

(c) Instead of complying with section 8.20.1.5(5) of ASTM F963-17, comply with the following:

(1) Floor and tabletop toys that move, where the sound is caused as a result of the movement imparted on the toy (for example, a noise making mechanism attached to an axle of a toy vehicle) shall be tested using the method for push and pull toys. In addition to the C-weighted peak measurement maximum A-weighted sound pressure level, LAFmax, shall be made and compared to the requirements of 4.5.1.2.

(2) [Reserved]

[82 FR 8993, Feb. 2, 2017, as amended at 82 FR 57123, Dec. 4, 2017]

return arrow Back to Top